Juniper ACX500 Hardware Manual page 181

3. Remove the screw cover cap protecting the power terminal on the faceplate.
shows the location of the power terminal.
Figure 62: Power Terminal Location on the ACX500 Outdoor Router
Interface port cover
1
—
Cable connector ports with dust cover
2
—
4. Insert the appliance coupler terminal end of the power cord into the appliance inlet on the power
supply. Ensure that the power cord terminal is connected properly.
CAUTION: You must ensure that power connections maintain the proper polarity. The
power source cables might be labeled (+) and (–) to indicate their polarity.
Management port cover
3
—
Power port with dust cover
4
—
Figure 62 on page 172
172