Setpoint Channel (Master To Drive) - Siemens SIMOVERT FC Series Operating Instructions Manual

Master Drives
CBD
01/23/98
5.2.1

Setpoint channel (master to drive)

...Section Start-up / parameterization "Expert application" of the drive Instruction Manual
Change process
data wiring ?
no
Connect receive
channel:
- control words
- setpoints
Other CBD relevant
Continue in Section Start-up / parameterization "Expert application" of the drive Instruction Manual.
Fig. 5.3 Process data combination, setpoint channel
The process data combination of the setpoint channel can also be set via the DeviceNet™ bus, if
"parameterizing enable" was previously set to an uneven number (5.1 Parameterization).
♦ Using the "tens digit" of the combination value, a differentiation is made between 16-bit process data (e.g. 3002)
and 32-bit process data (e.g. 3032).
♦ If process data is transferred as 16-bit quantity, then set the selector switch (refer to the Section "Process data"
in the drive Instruction Manual"), to the required combination value, associated with the PZDI, for 16-bit process
data (example: PZD2 occupied by 16-bit process data; the associated combination value is then 3002).
♦ If process data is transferred as 32-bit quantity, then set the selector switch (refer to the Section "Process data"
in the drive Instruction Manual"), to the required combination value associated with the PZDi for 32-bit process
data. In this case, use the combination value of the least significant PZDi (example: PZD2+PZD3 occupied by
32-bit process data; the associated combination value is then 3032).
Siemens AG 477 759 4070 76 J AA-74
SIMOVERT MASTER DRIVES
5 Start-up
5.2 Process data combination
5.2.1 Setpoint channel (master to drive)
yes
Connect response
channel:
- status words
- actual values
parameters
Betriebsanleitung / Operating Instructions
Refer to Section 4.3.1
Refer to Section 4.3.2
Refer to Section 4.3.3
NOTE
41