Table of Contents
Advertisement
CAUTION:
or insert a VCCI module.
See these topics for instructions for installing and removing components:
Installing an AC or DC Power Supply in an XRE200 External Routing Engine on page 96
Removing an AC or DC Power Supply from an XRE200 External Routing Engine on page 95
Installing a Fan Module in an XRE200 External Routing Engine on page 93
Removing a Fan Module from an XRE200 External Routing Engine on page 92
Installing an HDD Module in an XRE200 External Routing Engine on page 103
Removing an HDD Module from an XRE200 External Routing Engine on page 102
Installing a VCCI Module in an XRE200 External Routing Engine on page 101
Removing a VCCI Module from an XRE200 External Routing Engine on page 99
SEE ALSO
XRE200 Cooling System | 33
AC Power Supply in an XRE200 External Routing Engine | 35
Virtual Chassis Control Interface (VCCI) Modules in an XRE200 External Routing Engine | 42
Hard Disk Drive (HDD) Module in an XRE200 External Routing Engine | 43
Removing a VCCI Module from an XRE200 External Routing Engine
XRE200 External Routing Engines have two Virtual Chassis Control Interface (VCCI) module slots on the
front panel. The slots support 10/100/1000BASE-T RJ-45 and 1000BASE-X Gigabit Ethernet small
form-factor pluggable (SFP) VCCI modules. The VCCI modules are offline field-replaceable units (FRUs).
You can use this procedure for both types of VCCI modules.
Ensure that you have the following parts and tools available to remove a VCCI module:
Phillips (+) screwdriver, number 2
An antistatic bag or an antistatic mat
You must power off the external Routing Engine if you need to remove
99
Advertisement
Table of Contents
