Juniper XRE200 Hardware Manual page 89

8. Specify all members for the Virtual Chassis, listing each switch's or external Routing Engine's serial
number, member ID, and role:
[edit virtual-chassis]
user@external-routing-engine# set member member-id serial-number serial-number role role
For example:
[edit virtual-chassis]
user@external-routing-engine# set member 0 serial-number abc123 role line-card
user@external-routing-engine# set member 1 serial-number def456 role line-card
user@external-routing-engine# set member 2 serial-number ghi789 role line-card
user@external-routing-engine# set member 3 serial-number jkl101 role line-card
user@external-routing-engine# set member 8 serial-number yza567 role routing-engine
user@external-routing-engine# set member 9 serial-number bcd890 role routing-engine
NOTE: An EX8200 Virtual Chassis does not function properly when an external Routing
Engine is configured to use a member ID other than 8 or 9. When the EX8200 Virtual Chassis
configuration is not preprovisioned, the external Routing Engine assumes a member ID that
is not 8 or 9. The EX8200 Virtual Chassis cannot be formed until this member ID configuration
is changed using this procedure.
9. Interconnect the member switches and external Routing Engines. See
to an XRE200 External Routing Engine" on page
on page 78, and Setting a 10-Gigabit Ethernet Port as a Virtual Chassis Port in an EX8200 Virtual Chassis
(CLI Procedure).
10. Commit the configuration:
[edit]
user@external-routing-engine# commit synchronize
11. Power on the backup external Routing Engine if it is not already powered on.
RELATED DOCUMENTATION
Example: Setting Up a Full Mesh EX8200 Virtual Chassis with Two EX8200 Switches and Redundant XRE200
External Routing Engines
"Connecting an EX8200 Switch
84, "Interconnecting XRE200 External Routing Engines"
89