Replacing The Ac Power Supply Module On A Junos Space Appliance; Removing The Ac Power Supply Module - Juniper JA2500 Junos Space Hardware Manual

JA2500 Junos Space Appliance Hardware Guide

Replacing the AC Power Supply Module on a Junos Space Appliance

Removing the AC Power Supply Module

126
Ensure that you have the following parts and tools available to remove the power supply
module from the appliance chassis:
(Optional) Electrostatic discharge (ESD) grounding strap
An antistatic bag or an antistatic mat
NOTE: If only one power supply module is installed in your Junos Space
Appliance, you must power off the appliance before removing the power
supply module.
This topic has the following sections:
Removing the AC Power Supply Module on page 126
Installing the AC Power Supply Module on page 127
To remove the AC power supply module, do the following:
Place an antistatic bag or an antistatic mat on a flat, stable surface.
1.
(Optional) Attach an electrostatic discharge (ESD) grounding strap to your bare wrist,
2.
and connect the strap to an external ESD point.
If the AC power source outlet has a power switch, set it to the OFF position.
3.
Gently pull out the male end of the power cord connected to the power source outlet.
4.
Remove the power cord from the power supply faceplate by detaching the power
5.
cord retainer and gently pulling out the female end of the power cord connected to
the power supply faceplate.
Slide the locking ejector lever to the right, as shown in
6.
in its furthest position.
Figure 15 on page 127, until it is
Copyright © 2018, Juniper Networks, Inc.