Table of Contents
Advertisement
General Site Guidelines | 54
Rack-Mounting and Cabinet-Mounting Warnings | 141
XRE200 Cooling System | 33
XRE200 Network Cable and Transceiver Planning
IN THIS SECTION
Pluggable Transceivers Supported on XRE200 External Routing Engines | 59
Cables Connecting the XRE200 External Routing Engine to XRE200 External Routing Engines and EX8200
Switches | 60
Cables Connecting the XRE200 External Routing Engine to Management Devices | 61
Pluggable Transceivers Supported on XRE200 External Routing Engines
The SFP Virtual Chassis Control Interface (VCCI) module for XRE200 External Routing Engines supports
SFP transceivers. You can find the list of transceivers supported on XRE200 External Routing Engines and
information about those transceivers at the
NOTE:
We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
The Gigabit Ethernet SFP transceivers installed in XRE200 External Routing Engines support digital optical
monitoring (DOM): You can view the diagnostic details for these transceivers by issuing the operational
mode CLI command show interfaces diagnostics optics.
Hardware Compatibility Tool page for
If you face a problem running a Juniper Networks device that uses a
XRE200.
59
Advertisement
Table of Contents
