Ac Power Supply Led In Xre200 External Routing Engines - Juniper XRE200 Hardware Manual

The 250W AC power supply supports both the low-line (100 VAC) and the high-line (240 VAC) AC power
configurations.
SEE ALSO
Installing an AC or DC Power Supply in an XRE200 External Routing Engine | 96

AC Power Supply LED in XRE200 External Routing Engines

An AC power supply has one bicolored power supply status LED on its faceplate. This LED displays
information about the status of the power supply (see
Figure 11: AC Power Supply LED on an XRE200 External Routing Engine
Ejector lever AC Power supply
status LED
Table 12 on page 36 describes the power supply status LED on an AC power supply in an XRE200 External
Routing Engine.
Table 12: AC Power Supply LED on XRE200 External Routing Engines
LED State
Unlit
Green
Yellow
Figure 11 on page
Description
Indicates one of the following:
Power supply is disconnected from AC power feed.
AC power input voltage is not within normal operating range.
No AC power input.
Power supply is functioning normally and is powering the system.
Power supply is in standby mode. The power supply is powered on but is not
providing power to the system.
36).
36