Installing An Hdd Module In An Xre200 External Routing Engine - Juniper XRE200 Hardware Manual

Unscrew both captive screws counterclockwise using your fingers. If you are unable to unscrew the
captive screws using your fingers, use the screwdriver.
3. Gently pull the HDD module toward you and out of the HDD module slot, being careful to keep one
hand underneath the module to support it when it is removed from the chassis.
4. Place the HDD module in the antistatic bag or on the antistatic mat.
Figure 38: Removing an HDD Module from an XRE200 External Routing Engine
Loosen captive screws.
SEE ALSO
Hard Disk Drive (HDD) Module in an XRE200 External Routing Engine | 43

Installing an HDD Module in an XRE200 External Routing Engine

XRE200 External Routing Engines have two 160 GB hard disk drive (HDD) module slots on the front panel.
HDD modules are hot-removable and hot-insertable field-replaceable units (FRUs).
Ensure that you have the following parts and tools available to install the HDD module:
A Phillips (+) screwdriver, number 2
CAUTION:
Routing Engine. Removing both HDD modules when the external Routing Engine is
powered on can cause severe hardware issues.
A single HDD module must be installed in a powered-on XRE200 External
103