Table of Contents
Advertisement
CAUTION:
insert a VCCI module.
To remove a VCCI module from an external Routing Engine (see
1. Place the antistatic bag or the antistatic mat on a flat, stable surface.
2. Power off the XRE200 Routing Engine. See
page
115.
3. Unscrew both captive screws counterclockwise using your fingers. If you are unable to easily unscrew
the captive screws with your fingers, use the screwdriver.
4. Gently pull the VCCI module toward you and out of the VCCI module slot, being careful to keep one
hand underneath the module to support it when it is removed from the chassis.
5. Place the VCCI module in the antistatic bag or on the antistatic mat.
Figure 36: Removing a VCCI Module from an XRE200 External Routing Engine
Loosen captive screws.
SEE ALSO
Virtual Chassis Control Interface (VCCI) Modules in an XRE200 External Routing Engine | 42
You must power off the external Routing Engine before you remove or
"Powering Off an XRE200 External Routing Engine" on
Figure 36 on page
100):
100
Advertisement
Table of Contents
