Virtual Chassis Port Leds On An Xre200 External Routing Engine - Juniper XRE200 Hardware Manual

Virtual Chassis Port LEDs on an XRE200 External Routing Engine

Each Ethernet Virtual Chassis port (VCP) on the XRE200 External Routing Engine—each VCP on the RJ-45
or SFP VCCI module as well as the native VCP (port 0)—has two LEDs.
Figure 7 on page 32 shows the VCP LEDs.
Figure 7: Gigabit Ethernet VCP LEDs on an XRE200 External Routing Engine
EX8200-XRE200
USB
CONSOLE
Link/Activity
LED
Table 10 on page 32 describes the Link/Activity LED.
Table 10: Gigabit Ethernet Port LEDs in an XRE200 External Routing Engine—Link/Activity LED
LED
Link/Activity
The LEDs labeled SPD indicate the current speed of the port.
Table 11 on page 32 describes the Speed LED.
Table 11: Gigabit Ethernet Port LEDs in an XRE200 External Routing Engine—Speed LED
LED
Speed
Speed
Disk Number
0 1
Slot Number
0 1 2
LINK/
LINK/ LINK/ LINK/ LINK/
ACT SPD
ACT SPD ACT SPD ACT SPD ACT SPD
0 1 2
MGMT 0
LINK/
ACT SPD
0
Color
Green
Color
Off
Green
3
Speed
LED
State and Description
On steadily—The port and the link are active, but there
is no link activity.
Blinking—The port and the link are active, and there is
link activity.
Off—The port is not active.
State and Description
Link/Activity LED is Off—port speed is 0 Mbps
Link/Activity LED is On steadily or blinking—port speed
is 10 Mbps
100 Mbps
32