Connecting The Xre200 To Management Devices; Connect A Device To A Network For Out-Of-Band Management - Juniper XRE200 Hardware Manual

SEE ALSO
DC Power Supply in an XRE200 External Routing Engine | 38

Connecting the XRE200 to Management Devices

IN THIS SECTION

Connect a Device to a Network for Out-of-Band Management | 83

Connecting an EX8200 Switch to an XRE200 External Routing Engine | 84
Connect a Device to a Management Console Using an RJ-45 Connector | 86
Connect a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel. Each device has
a management port to which you can connect an Ethernet cable with an RJ-45 connector. Use the
management port to connect the device to the management device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
shows the RJ-45 connector of the Ethernet cable supplied with the device.
Figure 26: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see
1. Connect one end of the Ethernet cable to the management port on the device.
2. Connect the other end of the Ethernet cable to the management device.
Figure 26 on page 83
Figure 27 on page 84):
83