Connecting Dc Power To An Xre200 External Routing Engine - Juniper XRE200 Hardware Manual

3. If the AC power source outlet has a power switch, set it to the OFF (0) position.
4. Insert the power cord plug into an AC power source outlet.
5. If the AC power source outlet has a power switch, set it to the ON (|) position.
6. Verify that the Power LED on the power supply is lit and is on steadily.
7. Repeat steps 2 through 6 for the second power supply.
Figure 24: Connecting an AC Power Cord to an AC Power Supply in an XRE200 External Routing Engine
SEE ALSO
AC Power Supply in an XRE200 External Routing Engine | 35

Connecting DC Power to an XRE200 External Routing Engine

After you have installed a DC power supply in an XRE200 External Routing Engine, you connect the external
Routing Engine to DC power.
WARNING:
from the DC circuit. To ensure that all power is off, locate the circuit breaker on the
panel board that services the DC circuit, switch the circuit breaker to the OFF position,
and tape the switch handle of the circuit breaker in the OFF position.
Before performing DC power procedures, ensure that power is removed
80