Management Port Leds On An Xre200 External Routing Engine - Juniper XRE200 Hardware Manual

Management Port LEDs on an XRE200 External Routing Engine

The management port (labeled MGMT) on the XRE200 External Routing Engine has two LEDs that indicate
link/activity and port status (see
speed is set to 100 Mbps.
Figure 6: LEDs on the Management Port on an XRE200 External Routing Engine
EX8200-XRE200
USB
CONSOLE
Link/Activity
LED
MGMT
Table 8 on page 31 describes the Link/Activity LED.
Table 8: Link/Activity LED on the Management Port on an XRE200 External Routing Engine
LED
Link/Activity
Table 9 on page 31 describes the Status LED (administrative status).
Table 9: Status LED on the Management Port on XRE200 External Routing Engine
LED
Status
Figure 6 on page
Disk Number
0 1
Slot Number
0 1 2
LINK/
ACT SPD LINK/ LINK/ LINK/ LINK/
ACT SPD ACT SPD ACT SPD ACT SPD
MGMT 0 0 1 2
Status
LED
Color
Green
Color
Green
31). The management port is set to full duplex and the
3
State and Description
Blinking—The port and the link are active, and there is
link activity.
On steadily—The port and the link are active, but there
is no link activity.
Off—The port is not active.
State and Description
On steadily—Administrative status is enabled.
Off—Administrative status is disabled.
31