Replacing Mini-Physical Interface Modules; Replacing Mini-Physical Interface Modules On The Srx300 Series And Srx550 High Memory Services Gateways; Removing A Mini-Physical Interface Module - Juniper SRX300 Series User Manual
High memory gateway interface modules reference
Hide thumbs
Also See for SRX300 Series:
- Reference manual (142 pages) ,
- Hardware manual (134 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
CHAPTER 14
Replacing Mini-Physical Interface Modules
Replacing Mini-Physical Interface Modules on the SRX300 Series and SRX550 High
Memory Services Gateways
Removing a Mini-Physical Interface Module
Copyright © 2017, Juniper Networks, Inc.
Replacing Mini-Physical Interface Modules on the SRX300 Series and SRX550 High
Memory Services Gateways on page 95
Before you begin, power off the services gateway.
CAUTION:
The Mini-Physical Interface Modules (Mini-PIMs) available are
not hot-swappable. You must power off the services gateway before removing
or installing Mini-PIMs.
To maintain proper airflow through the services gateway, cover any empty Mini-PIM slot
with a blank faceplate.
CAUTION:
Do not remove a blank faceplate unless you are installing a
Mini-PIM in the empty slot.
Removing a Mini-Physical Interface Module on page 95
Installing a Mini-Physical Interface Module on page 96
Removing a Blank Mini-Physical Interface Module Faceplate on page 97
Installing a Blank Mini-Physical Interface Module Faceplate on page 97
To remove a Mini-PIM from the services gateway:
Place an electrostatic bag or antistatic mat on a flat, stable surface on which you
1.
intend to place the Mini-PIM.
Attach an ESD grounding strap to your bare wrist, and connect the strap to the
2.
grounding point on the back of the device.
95
Advertisement
Chapters
Table of Contents
