Connecting Ac Power To An Xre200 External Routing Engine - Juniper XRE200 Hardware Manual

Figure 23: External Routing Engine to External Routing Engine Cabling
EX8200-XRE200
Disk Number
0 1
Slot Number
0 1 2
LINK/ LINK/ LINK/ LINK/ LINK/
USB ACT SPD ACT SPD ACT SPD ACT SPD ACT SPD
CONSOLE MGMT 0 0 1 2 3
SEE ALSO
Connecting an EX8200 Switch to an XRE200 External Routing Engine | 84
Adding or Replacing a Member Switch or an External Routing Engine in an EX8200 Virtual Chassis (CLI
Procedure)
Configuring an EX8200 Virtual Chassis (CLI Procedure) | 87

Connecting AC Power to an XRE200 External Routing Engine

After you have installed an AC power supply in an XRE200 External Routing Engine, you connect the
external Routing Engine to AC power.
Before you begin connecting AC power to an XRE200 External Routing Engine:
Install the power supply in the chassis. See
Routing Engine" on page
NOTE: Each power supply must be connected to a dedicated power source outlet to ensure
power supply redundancy.
Ensure that you have the following parts and tools available:
Power cords appropriate for your geographical location
CAUTION:
Engine is not a supported configuration.
To connect AC power to an external Routing Engine:
1. Ensure that the power supplies are fully inserted in the external Routing Engine.
2. Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate.
EX8200-XRE200
Disk Number
0 1
Slot Number
0 1 2
LINK/ LINK/
USB ACT SPD ACT SPD
CONSOLE MGMT 0 0
"Installing an AC or DC Power Supply in an XRE200 External
96.
Mixing different types of power supplies in the same external Routing
LINK/ LINK/ LINK/
ACT SPD ACT SPD ACT SPD
1 2 3
79