Removing An Xre200 From A Rack Or Cabinet - Juniper XRE200 Hardware Manual

CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
6. If there is a cable management system, arrange the cable in the cable management system to prevent
the cable from dislodging or developing stress points. Secure the cable so that it does not support its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the
cable management system. Placing fasteners on the loop helps to maintain its shape.
CAUTION:
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.

Removing an XRE200 from a Rack or Cabinet

IN THIS SECTION
Powering Off an XRE200 External Routing Engine | 115
Removing an XRE200 External Routing Engine from a Rack or Cabinet | 118
Do not leave a fiber-optic transceiver uncovered except when inserting
Do not let fiber-optic cable hang free from the connector. Do not allow
Avoid bending fiber-optic cable beyond its minimum bend radius. An
114