Removing And Installing Routing And Control Boards - Juniper MX10016 Hardware Manual

Table 55: FRUs in an MX10016 Router (continued)
FRU
Line cards
Optical transceivers
NOTE: If you have a Juniper Care service contract, register any addition, change, or upgrade of
hardware components at https://www.juniper.net/customers/support/tools/updateinstallbase/.
Failure to do so can result in significant delays if you need replacement parts. This note does not
apply if you replace an existing component with the same type of component.
RELATED DOCUMENTATION
MX10016 Transceiver and Cable Specifications | 115

Removing and Installing Routing and Control Boards

IN THIS SECTION
Removing a Routing and Control Board | 159
Installing a Routing and Control Board | 160
Type
Hot-insertable and hot-removable.
We recommend that you take line cards offline before removing them. You can
take line cards offline by using the request chassis fpc slot slot-number offline
command.
NOTE: Line cards are not part of the base configuration or redundant configuration.
You must order them separately.
Hot-insertable and hot-removable.
See "MX10016 Transceiver and Cable Specifications" on page 115
OS release in which the transceivers were introduced.
158
for the Junos