Table of Contents
Advertisement
DC Power Lug Specifications for an XRE200 External Routing Engine
To connect the DC power cables to the external Routing Engine, you must use cable lugs that have the
specifications shown in
Figure 13 on page
Figure 13: DC Power Cable Lug
.20
Thickness: .04
0.24
All measurements in inches
CAUTION:
must attach a cable lug to the power cables. A cable with an incorrectly attached lug
can damage the external Routing Engine.
You must use DC power cables that meet the following specifications: 14-12 AWG (1.9 mm2 minimum)
wire, or as required by the local code.
XRE200 Modules
IN THIS SECTION
Virtual Chassis Control Interface (VCCI) Modules in an XRE200 External Routing Engine | 42
Hard Disk Drive (HDD) Module in an XRE200 External Routing Engine | 43
Hard Disk Drive LEDs on an XRE200 External Routing Engine | 44
41.
.40
1.203
Before you install an XRE200 External Routing Engine, a licensed electrician
41
Advertisement
Table of Contents
