Replacing An Ac Power Supply On The Jsa5800 Appliance; Replacing Ac Power Supply Cables On The Jsa5800 Appliance - Juniper JSA5800 Hardware Manual

Hide thumbs Also See for JSA5800:

Table of Contents

Replacing an AC Power Supply on the JSA5800 Appliance

To replace an AC power supply:

1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on

the chassis.

2. Remove the power cord from the power supply.

3. Push the tab on the left edge of the power supply to the right.

4. Pull the power supply straight out of the chassis using the provided handle. Use one hand to support

underneath the supply as you remove it.

5. Orient the replacement power supply so that the tab is on the left side.

6. Using both hands, slide the replacement power supply straight into the chassis until the power supply

is fully seated in the chassis slot. Make sure the tab on the left edge of the power supply clicks into

place.

7. Attach the power cord to the power supply. If the power supply is correctly installed and functioning

normally, the power supply powers up immediately.

Contacting Juniper Networks Technical Assistance Center | 49

Replacing AC Power Supply Cables on the JSA5800 Appliance

To replace an AC power supply cord:

1. Unplug the power cord from the power source receptacle.

2. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on

the chassis.

Table of Contents