PTX3000 Packet Transport Router Quick Start
Connect AC Power to the PTX3000 AC Power Supply Modules
24
Connect Nonredundant AC Power to the PTX3000 AC Power Supply
Modules on page 24
Connect Redundant AC Power to the PTX3000 AC Power Supply Modules on page 24
Connect Nonredundant AC Power to the PTX3000 AC Power Supply Modules
To connect nonredundant power, see Connecting Nonredundant AC Power to the PTX3000
AC Power Supply Modules in the PTX3000 Packet Transport Router Hardware Guide.
Connect Redundant AC Power to the PTX3000 AC Power Supply Modules
WARNING:
You must ground the packet transport router before connecting
the packet transport router to power.
To connect AC power to the PTX3000 packet transport router:
Gather the following tools and parts:
1.
Electrostatic discharge (ESD) grounding wrist strap
AC power cords, which should have a plug appropriate for your geographical location
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
2.
ESD points on the chassis.
Switch the power switch on the PSM faceplate to the standby position (
3.
Loosen the captive screw on the PSM.
4.
Grasp the PSM, and pull it out to remove the PSM from the chassis (see
5.
Figure 21 on page
24).
Figure 21: Removing an AC PSM
Set the input switches for redundant power by setting both switches for input
6.
2
to the on position (
ON
) as shown in
Figure 22 on page
).
25.
Copyright © 2014, Juniper Networks, Inc.
and
1