Installing the CNA Module on the JSA7500 Appliance
To install the Converged Network Adapter (CNA) module on a JSA7500:
1. Power down the JSA7500 unit.
2. Unscrew the two thumbscrews on the right-most blank IOC modules and remove the dummy tray.
NOTE:
• The IOC module supports 10G connectivity with SFP+ transceivers. It supports only 1G
connectivity using dual-rate optics: UNIV-SFPP-DUAL-SR and UNIV-SFPP-DUAL-LR.
• The JSA7500 supports only the 2-port 10G IOC module in a one-half height tray.
3. Insert the 2-port 10G IOC module firmly and screw in the two thumbscrews. See
94.
Figure 16: JSA7500 with the CNA Card Inserted
Hard drive
1
—
Network port 0
2
—
Network port 1
3
—
Network port 2
4
—
IOC expansion slots
5
—
Network port 3
6
—
4. Power on the JSA7500 unit and watch it boot on the serial console.
5. Verify that the link and activity LED on the new 2-port 10G IOC module light up when you connect
the ports to your Ethernet switch with a duplex multi mode LC/LC MMF fiber optic cable.
USB ports
7
—
DB-9 Serial Console port
8
—
Power switch
9
—
Redundant power supply
10
—
Redundant power supply
11
—
Figure 16 on page
94