Table of Contents
Advertisement
EAW UMX.96 Owner's Manual
Appendix E: Technical Info
General Specifications
Frequency Response:
Dynamic Range
THD + Noise:
Equivalent Input Noise (EIN): –130 dBu, 20 Hz to 20 kHz BW, 150 ohm source, pad out
Residual Output Noise:
Sample Rates:
Digital Signal Processing:
Latency:
Maximum Voltage Gain:
Maximum Input Level:
Input Pad:
Mic Pre Gain:
Input Impedance:
Phantom Power:
AC Power Requirements:
LOUD Technologies Inc. is always striving to improve our products by incorporating new and improved ma-
terials, components, and manufacturing methods. Therefore, we reserve the right to change these specifica-
tions at any time without notice.
EAW is a registered trademark of LOUD Technologies Inc. All other brand names mentioned are trademarks
or registered trademarks of their respective holders and are hereby acknowledged.
©2008 LOUD Technologies Inc. All rights reserved.
20 Hz to 20 kHz (± 0.5 dB)
DA:
110 dB, main out @ 96 kHz
AD+DA:
105 dB, mic in to main out @ 96 kHz (up to +45 dB mic gain)
DA:
114 dB, main out @ 48 kHz
AD+DA:
109 dB, mic in to main out @ 48 kHz (up to +45 dB mic gain)
< 0.004%, mic in to main out @ 1 kHz
(mic in = –15 dBu, mic gain = +31 dB)
–127 dBu, 20 Hz to 20 kHz BW, any source impedance, pad in
–90 dBu, 20 Hz to 20 kHz BW, all inputs muted
44.1, 48, 88.2, 96 kHz
32-bit and 40-bit floating point resolution
3.1 ms, analog mic in to analog main out, system processor bypassed
3.6 ms, analog mic in to analog main out, system processor engaged
89 dB, mic in to main out
30 dBu, pad engaged
23 dB, digitally controlled
+15 to +70 dB, 1 dB steps (pad out, digitally controlled)
–8 to +47 dB, 1 dB steps (pad in, digitally controlled)
1.5 kΩ, mic in, pad out
3.1 kΩ, mic in, pad engaged
10 kΩ, inserts, returns, and stereo inputs
+48 VDC
1000 W, 90-264 VAC, 47-63 Hz, dual-redundant power supply
A-6
Appendices
Advertisement
Table of Contents
