Table of Contents
Advertisement
EAW UMX.96 Owner's Manual
• Comp/EQ IN buttons — Enables the compressor and EQ. The small displays show a miniature view of the
compressor transfer curve and the EQ graph. You can adjust the processors via the EQ or Comp tabs at the
top of the touchscreen or by touching the screens below the Mute Groups or VCA Groups buttons.
Between the Compressor and the EQ IN buttons is a double-ended arrow button. This button swaps the
order of the equalizer and compressor in the signal path, allowing you to compress before or after the EQ.
Each press of the button changes the order.
• Insert Post EDIT button — Post-DSP digital insert point. Touching the EDIT button accesses the Inserts
screen, the same as touching the Inserts tab. The readout below the button displays the name of the
selected insert device.
• Analog Insert point — A DAC/ADC pair driving a half-normalled set of TRS insert jacks, located on the
rear panel. The IN button enables this part of the signal path. If the button is not enabled, the DAC/ADC
pair are not part of the circuit. Since this adds latency to the signal, enable it only if it is going to be used.
• Mute ON button — Enables the channel mute.
• Solo ON button — Sends the channel's signal to the solo bus. The soloed signal is always pre-output DSP.
• Fader — The Aux/Group channel fader. The readout below the knob on the touchscreen displays the
fader value in dB.
• Pan (Group only) — Pans the signal across the assigned mix buses.
• Mix Assign (Group only) — Assigns the channel's signal to the L/R buses and the Center bus.
• Mute Groups — Eight buttons that assign the Aux/Group channel to any of the eight mute groups.
• VCA Groups — Sixteen buttons that assign the Aux/Group channel to any of the sixteen VCA groups.
• Invert button — Inverts the polarity of the signal by 180 degrees.
• 31 Bd EQ button — Engages the 31-band graphic equalizer, which appears at the bottom of the overview
screen.
• Output Delay IN button — Enables the alignment delay for the Aux/Group. Parameters are adjusted in
the Delay tab.
• Output Level Meter — Level meter that displays the pre-fader level of the Aux/Group.
• EQ Display and IN button — Display showing the three-band EQ, the same as in the mono input channels.
12-35
Touchscreen Interface
Grp Overview
Advertisement
Table of Contents
