Expansion Tab; Administration Tab - EAW UMX.96 Owner's Manual

EAW UMX.96 Owner's Manual
• Send MIDI Program Change on Console Snapshot Change: On or Off (default Off ) — When enabled, the
TT24 sends a MIDI program change command when a snapshot is recalled equal to the snapshot number
of the selected MIDI channel.
• MIDI Out Channel Number: 1-16, or All (default 1) — The MIDI out channel to send the MIDI program
change command.
• Change Console Snapshot on MIDI Program Change: On or Off (default Off ) — When enabled, the con-
sole recalls a snapshot upon receipt of a MIDI Program Change command. The snapshot number match-
ing the program change number is recalled.
• MIDI In Channel Number: 1-16, or All (default All) — Selects the MIDI In channel to monitor for program
change commands.
• MIDI Enabled buttons — When enabled, sends MIDI note commands for mutes and continuous control-
lers for faders. The console also responds to these same MIDI commands.
• Snapshot Chase MTC button — When enabled, incoming timecode causes snapshots to load according
to their previously set time code numbers. Refer to Section 11.16.
• Frame Rate display — Displays the Frame rate of the incoming timecode stream.
• Incoming MTC display — Displays the timecode value of the incoming timecode stream.
12.10.5

Expansion Tab

This tab's screen allows configuration of a connected expansion device. If no expansion device is present it
NYI
displays a blank panel.
12.10.6

Administration Tab

NYI
The Administration tab allows independent locking and password protection of the console and system
processor. When a part of the console or system processor is locked, no changes are allowed. Sections of
the user interface can be locked to simplify console operation and to prevent changes to things like routing,
matrix, etc.
12-90
Touchscreen Interface