_________________________________________________________________
To enter a non-US Mode-S registration number set the 'ADDRESS TYPE' to 'HEX
ID' and enter the Mode-S registration number in the 'ADDRESS' field. Ensure the
'FLIGHT ID TYPE' is set to 'CONFIG ENTRY' or 'PFD ENTRY'. The CONFIG
ENTRY allows the Aircraft Registration/ID number to be entered once and stored in
memory by entering the Registration/ID number in the 'FLIGHT ID' field. PFD
ENTRY allows the pilot to enter the Registration/ID number from the PFD, via the
'TMR/REF' softkey.
10.6
SOFTWARE CONFIGURATION TROUBLESHOOTING
Problem
The MFD or PFD does not power up.
Software file load fails:
Configuration file load fails:
G1000 System Maintenance Manual
190-00907-00
NOTE
Solutions
•
Ensure power is present at display backshell
connector.
•
Replace the MFD or PFD.
•
Ensure that LRU is reporting data on the System
Status page (LRU is 'ONLINE'). Check data path
wiring as needed.
•
Restart MFD & PFD in configuration mode and
retry software file load or try using a different card.
•
Ensure that the MFD is not touched during the
loading process, unless explicitly instructed to do
so.
•
Ensure that LRU part number is compatible with
software version and loader card. Refer to
approved post-installation and/or maintenance
data.
•
Replace LRU.
•
Ensure that LRU is reporting data on the System
Status page (LRU is 'ONLINE'). Check data path
wiring as needed.
•
Restart MFD & PFD in Configuration Mode and
retry configuration file load or try using a different
card.
•
Ensure that the MFD is not touched during the
loading process, unless explicitly instructed to do
so.
•
Ensure that LRU part number is compatible with
software version and loader card. Refer to
approved post-installation and/or maintenance
data.
•
Replace LRU.
Page 10-7
Rev. B