Garmin G1000 Maintenance Manual page 169

_________________________________________________________________
7.13.3 Activation for GDU Software Versions 7.00 and Higher
1. Insert the Unlock card in the upper slot of the PFD.
2. Apply system power and place both displays in Configuration Mode.
3. After the SYSTEM STATUS page appears on the PFD, use the small FMS knob to turn to
the SYSTEM UPLOAD page.
4. Activate the cursor. Use the small FMS knob to select CONFIGURATION FILES in the
AIRFRAME field and press the ENT key.
5. Highlight the FILE field. Use the small FMS knob to select the 'Enable <feature>' option and
press the ENT key. Once the option is selected, the configuration files in the PRODUCT
field will be displayed. All files should be checked. If not, press the CHK ALL softkey.
6. Press the LOAD softkey.
7. Monitor the status of the upload. When the upload is finished, press the ENT key to
acknowledge the upload complete confirmation.
8. View the SUMMARY field and ensure that the item is 'COMPLETE'.
9. De-activate the cursor.
10. Power down the system and remove the Unlock card from the PFD.
7.13.4 Optional Equipment Configuration
The following configuration options are available for some G1000 equipped aircraft:
•
KN63 DME
•
KR87 ADF
•
Becker 3502 ADF
•
Artex C406-N ELT
•
KTA870 TAS
•
CO Guardian
•
GDL 90
•
KAP 140
•
GFC 700
•
Oxygen
•
WX500 StormScope
•
Ryan TAS 9900BX
If these optional systems are installed in the aircraft, follow the procedure below to configure
the G1000.
G1000 System Maintenance Manual
190-00907-00
Page 7-43
Rev. B