Section 8-Return To Service Testing; System Status Page (Configuration Mode) - Garmin G1000 Maintenance Manual

_________________________________________________________________
RETURN TO SERVICE TESTING
The return to service testing checks various secondary communications paths to ensure that the paths are
functioning correctly. Verify the LRU software part number and version against those listed on the
required equipment list after reinstalling any LRU.
1. Start the system in configuration mode. The System Status Page displays a list of LRUs in the LRU
window (Figure 8-1).
2. Activate the cursor and highlight the LRU window.
3. Use the FMS knob to scroll through the list in the window and select the displayed LRUs.
4. The software part number and version is displayed in the DATA window. Compare this to the
software configuration shown in the Required Equipment List. It is important that the software
versions be checked and validated according to the listed versions in the Required Equipment List.
Software configuration is a critical part of the G1000 operation and must be verified before returning
an aircraft to service.
G1000 System Maintenance Manual
190-00907-00
SECTION 8
Figure 8-1. System Status Page (Configuration Mode)
Page 8-1
Rev. B