Garmin G1000 Maintenance Manual page 134

_________________________________________________________________
8. Activate the cursor, turn the small FMS knob to show the list of GIA choices, highlight
GIA2 in the pop-up box and press the ENT key.
9. Press the SET>ACTV softkey in the lower left corner of the screen.
10. When the "Activate parameter settings?" window appears, verify OK is highlighted and
press the ENT key.
11. When the "GIA #2 Configured" window shows "Complete", press the ENT key to select
OK in the window.
12. Turn off the system.
New, Repaired or Exchange GIA Installed:
If a new, repaired or exchange GIA is installed, load the following files after removing the
supplemental database cards from the bottom slots of each display. Note which card was
removed from the MFD so it may be identified later for reinsertion in the MFD when software
and configuration loading is complete. It contains a FliteChart® or ChartView database which is
only used by the MFD. Reinstall all the cards after the software and configuration file loads are
complete.
• GIA1 Software
•
GIA2 Software
• GPS1 Software
• GPS2 Software
• GIA1 Configuration
• GIA2 Configuration
• GIA Gains
• GIA Audio
• GIA1/2 Files for optional equipment installed on the aircraft (i.e. ADF, HF radio, TAS, etc.).
Determining Current Boot Block Software Version
If a replacement GIA 63 (Non-WAAS) has been installed, the following procedure
applies. Non-WAAS GIA v4.01 (or later) boot block software must be installed prior to
upgrading to the GIA software versions listed in this document. Boot Block software is
available from the OEM provided G1000 software CD-ROM or free from the Dealer's
Only section of Garmin's website (www.Garmin.com).
A quick way to tell if GIA Boot Block needs to be updated is if an audio software loading
file fails. If it does, then the GIA Boot Block software needs to be updated.
1. Ensure the G1000 is powered off.
2. Remove the Supplemental Database cards from the bottom slots of each display. Note
which card was removed from the MFD so it may be identified later for reinsertion in the
MFD when software and configuration loading is complete. It contains a FliteChart or
ChartView database which is only used by the MFD.
3. Insert the airframe specific software loader card (containing GIA main software version
4.00 or later) into the top slot of the PFD.
4. While holding the ENT key on the PFD, restore power to the PFD.
Page 7-8
Rev. B
NOTE
G1000 System Maintenance Manual
190-00907-00