Garmin G1000 Maintenance Manual page 64

__________________________________________________________________
Symptom
SD card is stuck in GDU
A button/knob/joystick does
not appear to function
Terrain/Obstacle/Safetaxi/Flite
Charts does not display on
map
Page 5-28
Rev. B
Recommended Action
•
DO NOT insert a screwdriver of any length into the card slot.
•
DO NOT pry against the overlay.
•
DO NOT force the SD Card out.
•
Use a small screwdriver in the groove on the side of the exposed
end of the card to help pull out the card.
•
Push the card in further to release the card locking mechanism.
•
Check SD Card for having more than one label. Two or more
labels on the card will cause sticking.
−
Remove all but one label.
•
Insure the SD card is from SanDisk. Use of other brand of SD
Cards is not recommended due to variances in card thickness.
•
If card was inserted with the label facing to the right, do not
attempt to remove. Return the unit to Garmin for repair.
•
Go to the GDU TEST page in configuration mode and verify
button, knob, or joystick operates correctly by observing a change
in color from red to green in the button/knob/joystick icon when
the button/knob/joystick is pressed. If a button is stuck, the button
icon will be green without pressing the button as soon as you turn
to the GDU TEST page.
•
If problem is verified, replace GDU.
•
Ensure supplemental data cards are inserted correctly in the
lower slots of all three GDU's.
•
Allow the system to verify the data on the cards for approximately
five minutes after power-up.
•
If a database does not activate, reload the problem database onto
the SD Card or replace the card.
G1000 System Maintenance Manual
190-00907-00