Configuration Module - Garmin G1000 Maintenance Manual

_______________________________________________________________________
6.14

CONFIGURATION MODULE

To remove:
1. Remove two screws (item 8) from cover (item 7) and remove cover.
2. Unplug connector from configuration module (item 1).
3. Remove configuration module.
To install:
1. Inspect connector for damaged pins.
2. Place configuration module (item 1) in position.
3. Insert connector into configuration module (item 1).
4. If the GRS configuration module is replaced, proceed to Section 7.6.
5. If the GDC configuration module is replaced, proceed to Section 7.5.
6. If master configuration module is replaced:
7. Turn the PFD on in configuration mode. (press and hold the ENT key while powering the unit.)
8. Go to the Configuration Upload Page in the System Page Group.
9. Press the UPDT CFG softkey.
10. If the PFD and master configuration module is replaced, proceed to Section 10.
If the master configuration module is replaced, the G1000 system ID number will
change. The Terrain, TAWS Unlock, Chartview/Jeppview/FlightCharts and
other SD cards may need to be replaced since they will be locked to the old
system ID number. Contact Garmin for assistance in determining which cards
will need to be replaced.
Page 6-6
Rev. B
Figure 6-2. Configuration Module
NOTE
G1000 System Maintenance Manual
190-00907-00