Optional Systems - Garmin G1000 Maintenance Manual

_________________________________________________________________

7.13 Optional Systems

This section describes the steps that must be completed in order to configure the G1000 for
optional systems. Only those systems that are installed must be configured.
ChartView databases are subscription-based and are to be procured by the aircraft
owner directly from Jeppesen. This procedure is only required if the ChartView option is
purchased by the customer.
If the configuration for an optional system is inadvertently loaded for a system
that is NOT installed, the LRUs listed in the optional file must have their
configuration file reloaded from the BASE or Full Configuration file. Following
this, the configuration for the optional systems must be repeated.
7.13.1 Activation Procedure for TAWS, ChartView, SAR and SVT
The Unlock card can only enable the feature on one G1000 system (one aircraft). The
available unlock cards are –
•
TAWS Unlock, P/N 010-00330-51
•
SAR Unlock, P/N 010-00330-52
•
ChartView Unlock, P/N 010-00330-53 (Piston Aircraft Only)
•
ChartView Unlock, P/N 010-00330-50 (Turboprop Aircraft Only)
•
SVT Unlock, P/N 010-00330-54 (Single PFD Aircraft Only)
•
SVT Unlock, P/N 010-00330-55 (Dual PFD Aircraft Only)
7.13.2 Activation with GDU software version less than 7.00
1. Insert the Unlock card in the upper slot of the PFD.
2. Apply system power and place both displays in Configuration Mode.
3. After the SYSTEM STATUS page appears on the PFD, use the small FMS knob to turn to
the CONFIGURATION UPLOAD page.
G1000 System Maintenance Manual
190-00907-00
NOTE
Page 7-41
Rev. B