Peripheral Connections - ECS NEATSX User Manual

Hardware Specifications

Peripheral Connections

Keyboard
The NEATsx has a standard keyboard connection port at the
rear of the board. The jack from the keyboard plugs into the port once
the board has been installed in the case.
Power Supply
The NEATsx requires a power supply of at least 180 Watts in
order to be used in a fully configured system. Such a system includes
a hard disk drive and more than a minimum number of expansion
cards. The power supply should preferably be of the type that has a
"power good" signal. The power supply commonly supplied for AT-
type system boards has this feature.
If you wish to use a power supply that does not have a "power
good" signal, you can do so by setting a jumper on the NEATsx
board. Full details of this procedure are given in the Hardware Setup
section. If you are purchasing a unit yourself, ask the dealer for advice
if you are in doubt as to the correct choice.
24