If your system is already set up, you will not need to use
QuickSet unless you want to make a change in the hardware configu
ration. If EMS memory will be added, the appropriate information
must be entered using section 3 (SET EMS MEMORY) of QuickSet.
To use QuickSet the NEATsx board must be installed in a
fully functioning system with a minimum of one floppy disk drive.
How To Use QuickSet
The Quickset main menu lists six items. The program is struc
tured as a hierarchy with successive levels within each section. Move
ment between or within different sections of the program is accom
plished using the cursor (arrow) keys and the PgUp/PgDn keys.
There's a note at the bottom of each screen in Quickset regarding
these.
The <Enter> or <Retum> key is used to move between levels
of the program and to select settings. The <Esc> key lets you abort
settings and/or retreat to higher (or previous) levels of the program.
Software Setup
47