Hardware Setup
Switching the Battery Source
Jumper J2 controls the setting for either an internal or an exter
nal battery. The NEATsx will normally be set to ran off its on-board
battery if it is already installed in a system. Therefore, the factory set
ting is for an internal battery. If an external battery source is attached
(to connector Jl), the jumper J2 must be re-set. The figure below illus
trates the appropriate settings.
As mentioned previously, it is recommended that this be done
only if your system will not be in use for several weeks. Since the sys
tem when on will automatically recharge the internal battery, it's best
to use this battery if you're using your system regularly.
40
BATT
1
NEATsx battery connector