Hardware Setup
CPU Oscillator
Jumper JP2 selects the oscillator that will be used by the
microprocessor. The setting is based on the speed of the microproces
sor. The jumper is factory set for the 32 Mhz oscillator, the setting for
the 16 Mhz microprocessor. This default setting will not need adjust
ment. In a 20MHz CPU model the board will operate at 20MHz by
adding an oscillator. Short pins 1-2 (default) for 32 Mhz, OSC1; pins
2-3 for option oscillator, OSC2. The factory setting (short 1-2) is
shown in the figure below.
O scl for 16M Hz
operation (default)
30
JP2
JP2
Osc2 for 20 MHz
operation
NEATsx CPU oscillator settings