After Installation Setup - ECS NEATSX User Manual

Hardware Setup
After Board Installation Setup
After the NEATsx has been installed in a system case there are
some additional connections that may be made to the board. The In­
stallation section contains a brief description of how to install the
NEATsx system board in a case.
Case Connections
There are five connectors on the NEATsx that can be attached
to indicators or devices on a system case if they are present They are:
• Keylock/Power LED connector (J10)
• H/W Reset Switch connector (J9). ON: RESET
• Processing Speed (or Turbo) Switch connector (J6)
• Processing Speed (or Turbo) LED connector (J8)
Speaker connector (J7)
PIN 1: +5 V PIN 4: Keylock
PIN 2: NC PIN 5: Ground
PIN 3: Ground
ON: NORMAL OFF: TURBO