Software Setup
AMI BIOS
The AMI BIOS setup program mentioned previously is used to
establish the system hardware setup. If your NEATsx is already in
stalled in a working system, you will not need to use this program un
less you desire to modify the current configuration already in CMOS
RAM. Should the information be lost due to battery failure, you will
need to rerun the setup and re-enter data for the configuration.
To complete the procedure, follow the instructions on the
screen as they appear. The initial prompt after turning on the computer
(or booting up) tells you to press the <Del> key if you want to run the
setup program. It is displayed briefly just after the RAM test. If it dis
appears before you have a chance to respond, turn the system off then
on again to cause the message to reappear, or just press the three keys
<CTRL>, <ALT>, and <DEL> simultaneously. The initial screen
prompt is:
Press <DEL> key to run SETUP/EXTD-SET
Software Setup