Setup; Jumper Switches - ECS NEATSX User Manual

Setup

This section is for setting up the NEATsx before installing it in
a system case. If your NEATsx is already installed in a system this
section can be ignored unless a change in the system configuration
needs to be made.

Jumper Switches

The NEATsx has several jumper switches that must be set to
define part of both the board and system configurations. These
switches are three-pin components that are turned on and off by plac­
ing or removing a cover cap over the pins. To turn a switch setting
"on", place a cap over two pins. This is called "shorting" the jumper.
All the jumpers must be set to one of two possible settings.
The location of the jumpers is noted on the Board Layout dia­
gram at the beginning of the manual. Their functions and settings are
noted in the following pages.
The NEATsx comes with the jumpers preset. The factory set­
tings are shown in the diagram on the following page.
Hardware Setup
27