ECS NEATSX User Manual page 44

Hardware Setup
These connectors look similar to jumper switches and vary in
number of pins. The indicators present on the case will have wire
leads extending from them with plastic female connectors attached.
The connectors should be plugged to the appropriate connecting pins
on the board.
The sets of connecting pins are clearly labeled. If the lead re­
quires a specific orientation, the pin 1 wire will generally be separated
from the other wires by a space. You should then orient the connector
so that this wire plugs onto pin 1 of the connecting pins on the board.
The pin 1 position is clearly marked beside the keylock connector.
38