ECS NEATSX User Manual page 69

Mounting Holes
The NEATsx has nine mounting holes drilled in the printed
circuit board. These will line up with some or all of the mounting
points on your case. Some form of mounting hardware is used to fas­
ten the board to the case. In some cases,the long inside edge of the
board fits under metal flanges in the case ñame rather than being
screwed to the case.
Mounting Fasteners
Cases can come with a variety of mounting fasteners, some
made of metal and some of plastic. In general the metal type will
screw into the case with another piece that screws the board to the fas­
tener. Plastic mounting fasteners usually use pressure fitting, snaping
first to the case and then to the board. One case may have both types,
the metal fasteners serving mainly to ground the board to the case.
Installation & Operation
63