Installing The Graphics Sheet; Installing The Flavor Card; Cart Information And Mounting - Cornelius VIPER E 2 FLAVOR Manual

Viper Installation, Service & Decommissioning Manual
I T G
NSTALLING HE RAPHICS
See Figure 10. for installing the merchandiser graphics.
Remove the screw from the top of the merchandiser door, flip the top cover backward and insert the graphic sheet. The graphic sheet
should be inserted between the diffuser and the clear plastic graphic lens. Once the graphics are in place, flip the top cover back to the
original position, replace and tighten the screw.
I T F
NSTALLING HE LAVOR
See Figure 11. for installing the flavor card.
Insert the flavor card in to the flavor card window as shown.
C I
ART NFORMATION AND
The Viper unit may be mounted on a mobile cart (Cornelius part no. 620043075 for 2-barrel unit, 620053990 for 3-barrel unit and
620046556 for 4-barrel unit) which allows some movement of the unit for service and cleaning. There are four captive nuts on the
bottom of the Viper to accommodate four 3/8-16 bolts. These bolts must be installed to secure the unit to the cart.
These carts are also designed with movable wheels that act as outriggers to provide stability to the unit when it is being moved.
!
WARNING:
The above listed mounting bolts must be installed and the wheels extended and locked in the outboard position prior to
moving the unit.
Failure to comply could result in serious injury, death or equipment damage.
This completes the initial installation of the unit. The following sections describe the control panel operation and commissioning the
unit.
Publication Number: 620073146SER
S
HEET
Figure 10.
C
ARD
Figure 11.
M
OUNTING
- 14 - © 2022, Marmon Foodservice Technologies Inc.