Cleaning The Syrup Connections; Servicing Motorman Dispensing Valves - Cornelius VIPER E 2 FLAVOR Manual

Hide thumbs Also See for VIPER E 2 FLAVOR:
Table of Contents

Advertisement

Step
7.
Replace the blade assembly and bushings (PN 2392) onto the motor shaft in the bar-
rel.
8.
Re-install the faceplate and replace the four (4) mounting nuts. Hand tighten the nuts
until the faceplate makes contact with the gasket, then use a wrench to tighten the
nuts an additional 1/4 turn. Be careful not to over tighten the nuts or cracking of the
faceplate may result.
9.
Refill the barrel with product. "Filling a Barrel" on page 67.
10.
When barrel fill is complete, perform a motor calibration. "Calibrating a Motor" on
page 73.

Cleaning the Syrup Connections

Syrup connections should be cleaned at least every six months, or when syrup types are changed. Perform the procedure in
Table 62 to clean the BIB connectors.
Step
1.
Open the merchandiser and select OFF for the barrel to be cleaned.
2.
Remove the quick disconnect from the BIB container.
3.
Fill a suitable pail or bucket with soap solution.
Submerge the disconnect in the soap solution and then clean it using a nylon bristle
4.
brush. (Do not use a wire brush). Rinse with clean water and dry.

Servicing Motorman Dispensing Valves

NOTE:
Dispensing valves with caged o-rings should be serviced (lubricated) every 6 months or more frequently if the valve lever gets tight
to operate. Caged O-rings should be replaced every 12 months.
Refer to and perform the procedure in Table 63 (see step 18) to lubricate or change the caged o-rings in each dispensing
valve on the unit.
Suggested Sanitizers
KAY-5® Sanitizer/Cleaner (100 PPM)
Mix one packet of KAY-5® Sanitizer/Cleaner per 2.5 gallons of tap water [70°-100°F (24°-35°C)] according to manufacturer's
instructions to ensure 100 PPM of available chlorine.
Household Bleach (200 PPM)
For 6% Sodium Hypochlorite bleach, mix 2.5 fl oz (75mL) in 5 gallons of tap water [70°-100°F (24°-35°C)]. For 5.25% Sodium
Hypochlorite bleach, mix 2.2 fl oz (66mL) of bleach in 5 gallons of tap water [75°-95°F (24°-35°C)]. This will ensure a bleach
solution of 200 PPM of available chlorine.
© 2022, Marmon Foodservice Technologies Inc.
Viper Installation, Service & Decommissioning Manual
Table 61
Action
Table 62
Action
- 79 -
Publication Number: 620073146SER

Advertisement

Table of Contents
loading

This manual is also suitable for:

R-454c

Table of Contents