Motor Setup Menu - Cornelius VIPER E 2 FLAVOR Manual

Motor Setup Menu

Motor setup is initially done at the factory and does not need to be changed unless a barrel motor or barrel components are
replaced, adjusted or removed and reinstalled.
This menu allows you to select different motor types for each barrel in the unit and run the calibration procedure on that
motor. This procedure correlates the actual viscosity of the barrel and its contents with the electrical characteristics of the
motor. These characteristics are stored by the control system and are accessed at the time of calibration for each particular
motor.
Because of the differences between motor characteristics from different motor suppliers, the Motor setup screen, shown in
, is used to adjust the unit settings to match the motor type being installed. It provides the correct table of electrical
Figure 59
characteristics from imbedded settings located in non-volatile memory. Perform the procedure described in Table 54 to
change the motor type setting. Insure that the motor type matches the settings listed in Table 52 based on model.
NOTE: If the Motor Type shown is "DEFAULT", it indicates that the EEPROM is not installed or is faulty.
Button
BACK
CAL
-
+
Step
1 Set barrel for Motor Type
2 Select the barrel
3 Select the proper motor type
4 Complete the procedure
© 2022, Marmon Foodservice Technologies Inc.
Table 52.
Model
All 60 Hz
All 50 Hz
Figure 59. Motor Setup Screen
Table 53.
Returns the display to the Select menu
Verifies the motor settings of a new motor.
Decrements the highlighted field
Increments the highlighted field
Table 54.
Action
From the Maintenance menu (), open the Motor Setup menu, shown
in Figure 59.
Use the Up and Down arrows to highlight the desired barrel
Press the + or - buttons at the bottom of the display to select the
proper motor type
Press the BACK button at the bottom of the display to save the settings
and return to the Setup menu.
- 71 -
Viper Installation, Service & Decommissioning Manual
Motor Type
1
2
Description
Procedure
Publication Number: 620073146SER