Cornelius VIPER E 2 FLAVOR Manual page 88

!
WARNING:

In Step 1, disconnect electrical power from the unit. Failure to disconnect the power could result in serious injury, death,
or equipment damage.
Step
1. Disconnect power from the unit.
2. Turn off and disconnect the water supply to the unit.
3. Remove the rear cover of the unit.
4. Disassemble the water filter (Use two wrenches, if necessary).
5. Remove the filter and rinse it under running water to remove any debris.
6. Reassemble the filter.
7. Connect and turn on the water supply to the unit.
8. Check the filter for any leaks.
9. Replace the rear cover.
10. Reconnect power to the unit.
© 2022, Marmon Foodservice Technologies Inc.
Viper Installation, Service & Decommissioning Manual
Table 69
Procedure
- 85 -
Publication Number: 620073146SER