Selecting A Location; Installing The Dispenser; Drop-In Dispenser; Free-Standing Dispenser - Cornelius Alta 1522 Installation Instructions Manual

Drop-in dispenser

Hide thumbs Also See for Alta 1522:

Specification sheet (2 pages)

Table Of Contents

Table of Contents

Alta 1522 Drop-in Dispenser Installation Instructions

The dispenser must be located near a permanent drain to route and connect the unit ice bin and drip tray drain

hoses. All drains and connections to such drains must meet local plumbing codes.

The unit must be located near a properly grounded electrical outlet. Circuit should be fused and no other electrical

appliance should be connected to the circuit. ALL ELECTRICAL WIRING MUST CONFORM TO NATIONAL AND

LOCAL ELECTRICAL CODES.

NSTALLING THE

WARNING:

It is the responsibility of the installer to ensure that the water supply to the dispensing equipment is provided with

protection back flow by an air gap as defined in ANSI A 112.1.2-1979; or an approved vacuum breaker or other such

method as proved effective by test and must comply with all federal, state and local codes.

Failure to comply could result in serious injury, death or damage to the equipment.

Water pipe connections and fixtures directly connected to a potable water supply

maintained according to Federal, State and Local

Drop-In Dispenser

1. Use the Template supplied to mark the location of the hole to be cut into the counter top. Cut the hole as marked

and remove the material.

2. Apply the double stick tape (if supplied with the loose shipped parts).

NOTE: To comply with the National Sanitation Foundation (NSF) requirements, the unit must be sealed to

the counter top.

3. Liberally apply a sealant, such as Dow Corning RTV 731 or equivalent, to the unit flange bottom surface.

4. Lower the unit into position to complete the seal of the rim to the counter top. Apply additional sealant

around the rim to ensure a complete seal.

CAUTION:

Do not move the unit after positioning or the seal may be broken.

5. Remove any excess sealant.

6. Mount the Transformer power supply under the counter, in a position to allow access to the electrical outlet

and to allow the 24V power cord to reach the dispenser.

7. Install the drain hose to the ice bin drain fitting and route the drain hose to a permanent drain.

Free-Standing Dispenser

1. Install the 6" legs to the dispenser cabinet if they are to be used.

2. Place the dispenser in the location selected. Be sure the dispenser is level. This is important to ensure that

the bin drains properly.

3. Mount the Transformer power supply in a convenient location to allow access to the electrical outlet and to

allow the 24V power cord to reach the dispenser.

4. Install the drain hose to the ice bin drain fitting and route the drain hose to a permanent drain.

Publication Number: 741200028INS