Table of Contents
Advertisement
24 February, 1999
Item
SP No.
[Display]
03-125: Process control method [Potential Control]
03-125-00
Process control method
[0:Auto. 1:FIX, 2:Auto+2/3 Spd]
03-126: Forced Process Control Self Check [Forced P-Ctrl Self Chk]
03-126-01
Self check: Execute
03-127: Target maximum toner M/A for process control gamma correction [P-control gamma target]
03-127-01
[Max M/A: K]
[Max M/A: Color]
03-127-02
03-128: Toner Density Correction [Toner Density Auto Control]
03-128-00
Toner density automatic correction
[0: ON, 1: OFF]
03-129: ID sensor pattern target toner M/A (toner supply control) [ID sensor Pattern Target]
03-129-01
[M/Aref: K]
03-129-02
[M/Aref: Color]
Default
Value Range
Step
Value
0
0 to 2
0 to 1
2
0.7mg/cm
0.5 to
0.001
2
1.5mg/cm
2
0.7mg/cm
0.5 to
0.001
2
1.5mg/cm
0
0 to 1
2
0.3mg/cm
0.100 to 1.500
0.001
2
2
mg/cm
0.4mg/cm
0.001
23
SP7-
902/3
1
Yes
Specifies whether process control is to be executed.
0: Automatic - process control enabled (keep the
machine at this setting in normal cases)
1: Fixed
Grid voltage V
development bias V
G,
power are all fixed values
2: Process control done at 2/3 speed, for printer
mode.
1
Does the forced process control self check.
See SP 3-975 for the results.
Yes
Adjusts the toner M/A target that is used for the
maximum in the process control gamma correction.
Do not adjust unless directed by technical support
Yes
staff.
1
Do not change the factory setting unless otherwise
directed by technical support staff..
Adjusts the target toner M/A on the ID sensor pattern
during toner supply control.
Do not adjust unless directed by technical support
staff.
SP TABLE
Description
ax LD
B, and m
Advertisement
Table of Contents
