Table of Contents
Advertisement
FILM PROJECTOR UNIT (A846)
[C]
9. Set the film strip holder [A] into the film projector unit at the base film setting
position.
NOTE: Push the film strip holder lightly to confirm that the film strip holder is
set correctly.
10. Turn on the test switch [B] on the projector control board and turn on the
projector unit main switch [C].
ø
CAUTION
The lamp housing and reflector [D] will become very hot. The lamp cooling
fan [E] will start turning suddenly when the lamp housing temperature
becomes high. Keep hands away from these components to avoid any
injury.
11. Loosen the wing nut [F].
12. Adjust the position of the projected light by turning the dial [G] with a hexagon
wrench [H] until it is at the center of the 4" x 5" frame [I] which is reflected in the
mirror unit.
13. Tighten the wing nut [F].
14. Turn off the projector main switch and the test switch.
15. Reinstall the lamp cover and other covers.
[I]
[A]
[D]
[F]
[G]
3-52
24 February, 1999
[B]
[E]
[H]
A846I503.WMF
Advertisement
Table of Contents
