DUPLEX UNIT
6.10.3 FEED ROLLER REPLACEMENT
[D]
[C]
[A]
1. Open the duplex unit.
2. Remove the guide rail [A] (1 screw and 1 snap-ring).
3. Remove the upper guide plate [B] and lower guide plate [C] (1 snap-ring).
4. Remove the inner cover [D] (2 screws).
5. Remove the 2 snap-rings [E] from both ends of the feed roller shaft.
6. Slide the bearings [F] inward.
7. Replace the feed roller [G] (2 E-rings, 2 paper flatteners [H], and 1 guide roller
[I]).
NOTE: 1) Be sure to install the feed and guide rollers correctly.
2) The feed roller is made of silicone rubber and is not compatible with the
non-silicone rubber feed rollers used in some previous models.
[B]
A259R572.WMF
[E]
[F]
6-78
24 February, 1999
[F]
[E]
[I]
[G]
A259R573.WMF
[H]