Table of Contents
Advertisement
24 February, 1999
A846I504.WMF
A846I507.WMF
16. Adjust the angle [A] of the mirror unit as follows:
1) Turn on the copier main switch and wait for the ready condition.
2) Open the lens cover and position the mirror unit on the exposure glass.
3) Set the correction filter [B] for positive films in the filter slot.
4) Turn on the projector main switch and press the Option key.
5) Perform shading using the positive 35 mm slides mode.
6) Set one of the orange base films in the slide holder and position it in the
projector unit.
7) Make a copy of the orange film.
8) Check if the orange image is even or not. If the image is uneven, adjust the
mirror angle as follows:
8-1)
When the leading part is dark [C].
a) Move the front and rear arm guides [D] to the left so that the mirror
angle is increased (2 screws each).
NOTE: Position the arm guides at the same location at front and
b) Make a copy of the orange film.
c) Repeat a) and b) until the orange image becomes even.
[A]
[C]
rear, using the ruler decals. This prevents the mirror from
being twisted.
3-53
FILM PROJECTOR UNIT (A846)
[B]
A846I505.PCX
A846I506.WMF
[D]
Advertisement
Table of Contents
