Table of Contents
Advertisement
24 February, 1999
[A]
[B]
6. Replace the developer cover (2 screws) and put the development unit [A] in the
drawer unit (2 lock screws [B]).
ø
CAUTION
1. When replacing the developer cover, do not apply excessive force to
the center of the development unit. The doctor gap will bend, altering
the developer scooping efficiency.
2. Make sure that the developer locks (front and rear) are secured with
screws before rotating the revolver. This protects the developer
assembly and locks from damage.
3. Tighten the developer lock screws firmly. Loose lock screws will cause
the PG (Photoconductor Gap) to fluctuate.
7. Remove the revolver stopper [C], rotate the revolver to the next color, then
follow the developer installation procedure from step 1.
NOTE: The revolver unit rotates counterclockwise. Do NOT try to turn it in the
other direction.
ø
CAUTION
If you do not install the revolver stopper before removing the development
unit, the revolver may rotate, causing permanent damage to the
development unit or its holder.
[B]
A259R302.WMF
3-15
COPIER INSTALLATION
[C]
A259I310.WMF
Advertisement
Table of Contents
